The thread used for bottoming is too thin or the angle is wrong

The thread used for bottoming is too thin or the angle is wrong, and the fabric cannot be fixed well. Because the paper under the fabric is too thin, it can't line up the fabric well. The computerized embroidery patte-making should consider the overall rationality of the needle; if you don’t walk a single needle in a local area, then just go straight to the place far away from the single needle to embroider a large flower, and then retu to use the needle package.

ufeffThere are ten main reasons for the patte movement of the computerized embroidery locomotive: China Spray Printing Embroidery Machines Manufacturers When making a patte, it should be printed from the center to the periphery as much as possible, so as to be more stable in the production process.

The single needle is wrapped up, so it’s very common to move in this way, it is not visible in the software, and it changes on the embroidery machine. The pulling force of the {cloth} paper on the embroidery machine should be just right, not too strong, otherwise it will change very simply Increasing the number of line changes will reduce the output power, but the possibility of positioning will decrease a lot, depending on how you combine the two. During the patte-making process, the bottom line is too close to the edge of the object.

Due to the repeated use of double-sided adhesive tape during the production process, the viscosity is reduced and the fabric is unable to be fixed. Due to the aging of the machine, the precision decreases and the position is shifted, such as: the same batch of embroidery, some are normal, and some are shifted Because the fluff on the surface of the cloth forms a position, it is more obvious when the cloth is pasted on the flannel.

China Big Embroideries...